Sold December 2005 Back to Archive

Bits for a 1 1/2 inch scale Allchin to Bill Hughes' well-known "Royal Chester" design.

• Pair hornplates with bearing brackets

• Crank and second shaft bearings

• Pair completed rear wheels, complete with wheel building jig

• One front wheel, rim for the other complete with wheel building jig

• Flywheel bored

• Smokebox front ring and door

• Pair dummy rear springs

• Cylinder block bored and faced

• Trunk guide bored

• Differential complete

• Tender in brass, part-finished

• Castings for valve chest, regulator bracket

• Grotty-looking part-built boiler

There is a complete set of as-new drawings. Parts and castings are still available from Reeves.

To see a super example of this engine when finished, there's a good one on the archive page.